Page 1 of 1
Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 08 Oct 2015 07:30
by iandvl
I've recently installed a set of Peter's plates (thanks again, Peter).
As such, I've removed the black plastic "bash-plate" (I use that term very loosely - it's anything but, but I am not sure what else to call it).
Available for free to a good home.
Ian
Re: Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 08 Oct 2015 09:39
by Mamba
Hi Ian,
Can you please bring it to Wolwekloof Saterday so that I can see if it will fit?
Thanks,
Re: Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 08 Oct 2015 09:39
by iandvl
Mamba wrote:Hi Ian,
Can you please bring it to Wolwekloof Saterday so that I can see if it will fit?
Thanks,
Will do so.
Re: Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 19 Oct 2015 19:11
by NMAD
iandvl wrote:Mamba wrote:Hi Ian,
Can you please bring it to Wolwekloof Saterday so that I can see if it will fit?
Thanks,
Will do so.
Did the plastic stone guard fit on the 4.8 GRX? I am keen to know as I would like one on my 4.8 GRX but its not listed on the parts data base for my model.
Re: Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 20 Oct 2015 07:33
by Mamba
Hi Noel,
The plastic stone guard didn't fit my pre-facelift 4.8 GRX
It is up for grabs again.
Re: Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 20 Oct 2015 09:47
by NMAD
Mamba wrote:Hi Noel,
The plastic stone guard didn't fit my pre-facelift 4.8 GRX
It is up for grabs again.
Ok thanks Mamba, I don't think it will fit on my patrol then either been the same engine.
Re: Stock Plastic "Bash" Thingy for 4.5 GU
Posted: 20 Oct 2015 17:01
by Peter Connan
I just want to say that this item is not a stone guard as it is far too flimsy to provide any protection to anything.
It's purpose is purely aerodynamic.