Re: Centre console replacement for Patrol
Posted: 03 May 2022 14:48
Did you manage to get around the load shedding? We had cables stolen Saturday morning and I was 3 hours into the print. By the time the power was restored the print had already warped fractionally, couldn't use it.ricster wrote: ↑03 May 2022 11:36 Ok, so we printed one out, customized it slightly (I'll take some pics and post them), but want to test it out in a hot cabin for a while first as we used a black PLA filament, which may go a little soft in the heat when parked in the sun and in a closed cabin.
Printing time took 34 hours of continuous printing. It's incredibly slow going and I didn't want to reduce the infilling too much due to using PLA. Like I said, I'll give you feedback once I've tested it out for a few days.
