Page 2 of 2
Re: Inner Axle Oil Seal
Posted: 23 Jul 2013 10:01
by ricster
Tell me the measurements .... as I guessed these ones, and I'll change my sketchup model
- seal tool.jpg (82.25 KiB) Viewed 6205 times
Re: Inner Axle Oil Seal
Posted: 23 Jul 2013 22:02
by Zantus
I actually use cad for a living, but in this case I just made quick hand sketch for the machinist at the lathe
I used 50mm BMS bar and the turned down section must be 33mm, about 15-20mm long. The bar needs to be about 200mm long if you want to install the seal with the knuckle in place, otherwise about 100mm long should be good enough.
Re: Inner Axle Oil Seal
Posted: 24 Jul 2013 09:21
by ricster
Updated sizes for the tool
- seal tool.jpg (106.89 KiB) Viewed 6187 times
Re: Inner Axle Oil Seal
Posted: 24 Jul 2013 09:23
by ricster
Zantus... did you manage to find "somewhere" yet.....
"I got the part numbers somewhere 
"
Re: Inner Axle Oil Seal
Posted: 24 Jul 2013 10:14
by Tinus lotz
Cool thanks for the tool sizes
Re: Inner Axle Oil Seal
Posted: 24 Jul 2013 14:50
by Stefan
Thanks Zanthus!
Could you send me the sketch Ricster?
Re: Inner Axle Oil Seal
Posted: 24 Jul 2013 15:01
by ricster
Do you want the sketchup model Stefan?
PM me your email address
Re: Inner Axle Oil Seal
Posted: 17 Aug 2013 22:31
by Zantus
ricster wrote:Zantus... did you manage to find "somewhere" yet.....
It's been a while, but I just found the invoice. Part numbers and descriptions are as per the invoice, and prices are the ex VAT prices.
OIL SEAL - 40227C8200 - R125
SEAL-GREASE FRT HUB - 4023201J00 - R75
SEAL-OIL INNER D/SHA - 4053301J00 - R257
Re: Inner Axle Oil Seal
Posted: 19 Aug 2013 08:46
by ricster
Thanks Zantus!!
Re: Inner Axle Oil Seal
Posted: 10 Oct 2014 09:13
by jonathan
Hi guys. It would appear that the time has come for me to replace the driver side axle oil seal on my trol. I just want to check and confirm if anybody has found an alternative to buying the seal from the dealers? Almost 600 bucks
for 3 oil seals just feels wrong!
