Thanks Ian, one thing that you might not be aware of is that this bumper design sits very snug around the quarter section....I actually had to hammer it in on certain places and grind small amounts off to get the bumper to fit.
Michael wrote:Ian, yes its where the factory recovery point mounts. Because of the new bumper disign there was a 75mm gap between the bumper and where the recovery point should mount.
I made a box of 6mm steel that fits inbetween the bumper an the recovery point mount on the chassis. I then bought new 120mm HT bolts that goes through the box and into the chassis
Michael wrote:So last week I took my Patrol for a dyno with Josh.
I upped the boost to 1 bar and it spikes to 1.1 bar, gave it some more fuel to match the boost and modified the aneroid fuel pin a bit to deliver a bit more fuel under full boost.
The results are higher than expected, but we will verify this at the next dyno day.....
181kw and 497Nm
Users browsing this forum: No registered users and 1 guest