4.8 Coolant Replacement

Engines and Engine Systems
Post Reply
User avatar
Bruin Beer
Senior Member
Senior Member
Posts: 312
Joined: 15 May 2012 19:49
Full Name: Riaan Delport
Nickname: Rooian
Home Town: Pretoria
Current 4x4: Nissan Patrol 4.8 GRX
Home Language: Afrikaans
Has thanked: 6 times
Been thanked: 21 times

4.8 Coolant Replacement

Post by Bruin Beer »

Guys,
Stumbled across this very useful information (certainly to me).
A while ago I drained the coolant on my4.8 to remove the thermostat housing as it started to show a slow leak where the housing started to corrode. As the coolant was fairly new because I replaced it not to long ago I drained it into a container.
Did the hole job and replaced the original coolant back into the system.
I knew I had an air lock as I was not able to get the amount I drained back in.
I started the engine to circulate the coolant and push the air out.
I continuously felt the hoses to determine when the thermostat open at which point I intended switching off and add water.
After a few minutes, and with the hoses still cold I suddenly realise something is wrong as the electric cooling fan came on. I immediately shut down the engine and could feel the block was warm but still no water flowing.
The heat of the block eventually conducted to the thermostat housing and eventually heated the thermostat to open enough to get the trapped air through.
Yes, while it was out I did check the small check valve and that was operating and perfect.
Well I stumbled across the following coolant bleed valve which I am convinced would have prevented the close call with great expenses.
Drawing1s.pdf
Wide angle
(495.25 KiB) Downloaded 1367 times
Drawing2s.pdf
closeup
(357.67 KiB) Downloaded 1053 times
Remove the plastic engine cover ( four 10mm screws) to expose the engine.
The read circle and yellow arrow indicate the bleed valve which according to the manual should be removed for draining the fluid and keep it open when refilling and only close when the water start to come out the bleed valve.
I will definitely follow this closely next time.
I am sure this would make the worlds difference and hope this could save someone else's bacon.
Bruin Beer
User avatar
Chris Skinner
Patrolman
Patrolman
Posts: 852
Joined: 26 Nov 2009 12:58
Full Name: Chris Skinner
Nickname: Chris
Home Town: Centurion
Current 4x4: Nissan Patrol 4,8 GRX 2005
Home Language: English
Has thanked: 10 times
Been thanked: 53 times

Re: 4.8 Coolant Replacement

Post by Chris Skinner »

Really close call!
Thanks for the heads up... :thumbup:
Clem
Patrolman
Patrolman
Posts: 902
Joined: 19 Jun 2013 15:16
Full Name: Clem Daniel
Nickname: Clem
Home Town: Johannesburg
Current 4x4: Patrol 4.8
Home Language: English
Has thanked: 35 times
Been thanked: 37 times

Re: 4.8 Coolant Replacement

Post by Clem »

That advice is worth money! Thank you!
User avatar
Tinus lotz
Moderator
Posts: 7579
Joined: 29 Aug 2010 13:07
Full Name: Tinus lotz
Nickname: Tinus lotz
Home Town: Centurion
Current 4x4: Nissan patrol 4.8 GRX 2005

Toyota 2.7 legend 35 LWB 4X4
Home Language: Afrikaans
Has thanked: 800 times
Been thanked: 549 times

Re: 4.8 Coolant Replacement

Post by Tinus lotz »

:thumbup:
User avatar
BABELAAS
Senior Member
Senior Member
Posts: 116
Joined: 03 Jan 2011 13:30
Full Name: LOWE
Nickname: MARC
Home Town: BRONKHORSTSPRUIT
Current 4x4: 2015 Navara 4X4
Home Language: ENGLISH
Been thanked: 3 times

Re: 4.8 Coolant Replacement

Post by BABELAAS »

Great tip , Cheers
BABELAAS

2015 Navara 4X4
Vloot
Full Member
Full Member
Posts: 20
Joined: 05 Jul 2010 22:03
Full Name: Johannes Rath Groenewald
Nickname: Vloot
Home Town: Pretoria
Current 4x4: Patrol Pickup TD42 2007
Home Language: Afrikaans
Been thanked: 1 time

Re: 4.8 Coolant Replacement

Post by Vloot »

:goodpost:
Post Reply

Return to “09. Engines”

Who is online

Users browsing this forum: No registered users and 3 guests